Expert Answers about GMC RV Wash Brush
- Can the Carr Light Wing Off-Road Light Mounting System # CARR167304 Be Left On In Car Wash
- The Carr Light Wing Off-Road Light Mounting System # CARR167304 is a sturdily built mounting bracket that would work just fine if you drove through a car wash with brushes. It would be more likely that the lights would have an issue, but if they are off-road type lights they would be made for rougher conditions and should be totally fine as well.
view full answer... - Possible Moisture Inside the Furrion Vision S Wireless RV Backup Camera System
- I suggest first off to ensure that the washing hasn't simply placed a fog over the lens caused from a residue. You may be surprised how often this is the cause opposed to actual moisture inside the device. Hopefully you find this to be the situation and then once cleaned, I suggest coating with Rain-X, # SLMRX11806D or a similar hydrophobic.
If you do have water within, I have found that the best way to remove acquired moisture from electronic items such as the Furrion Vision S Wireless...
view full answer... - How To Tighten The Fabric Of The SM Arnold RV Chenille Microfiber Wash Mop To The Handle
- You could tighten up the fabric on the SM Arnold RV Chenille Microfiber Wash Mop # 38185-332 by cutting a hole in the fabric where I have pictured below and run a thicker string or elastic band through each hole to pull the fabric tighter against the handle to prevent it from slipping off during use.
view full answer... - How To Secure The SM Arnold RV Chenille Microfiber Wash Mop Head To the Handle
- The mop head for the SM Arnold RV Chenille Microfiber Wash Mop # 38185-332 is a rubber material with a slot that matches up and holds the ring at the end of the handle to the mop head. Since there isn't a bolt to tighten these too items together the only way to really secure it would be to drill a hole through the rubber boot and through the handle itself and slip a carriage bolt through and secure it with a nut.
view full answer... - Recommended Cleaning Tips For The Teddy Bear RV Bunk Bed Mattress
- The Teddy Bear RV Bunk Bed Mattress - 74" Long x 28" Wide x 4" Tall # LC380765 is water resistant but not waterproof. I spoke with the manufacturer, Lippert, and they recommend using a carpet cleaner to wash and then suck out the water from the mattress and then let it lay out to fully dry. If you need replacement covers you can use # LC679284 for chocolate and # LC380765 for tan. The covers can be machine washed but also need to be laid out to dry and not machine dried.
view full answer... - How Can I Remove RV Roof Coating From The Side Of My RV?
- Sorry to hear about the troubles you're having!
To remove the Alpha Systems 4034 Roof Coating for RV Roofs # AL34CV from the side of your 1998 Tiago, you can use:
- A type of chemical paint remover,
- A Paint scraper tool,
- A Pressure washer,
Or
- A Knife to scrape it off.
view full answer... - Troubleshooting Lime Stains And Corrosion On Bathroom Faucets
- Lime will attach to any metal so the Phoenix Faucets Hybrid RV Bathroom Faucet - Single Lever Handle - Brushed Nickel
Item # PF232421 and a stainless steel faucet wouldn't really have much of a difference. The real problem is the how hard the water is and you can solve that with a water softener or filter. As for maintaining the faucets, it's recommended to use vinegar to clean and remove all corrosive contaminants.
view full answer... - Only One Brake Light is Working with the Peterson Magnetic Tow Light Kit
- You will want to verify that both brake light signals are working at the RV side trailer connector. Unplug the Peterson Magnetic Tow Lights # PE26UR, and use a circuit tester such as # PTW2992 to test the pins on the 4-Way while someone sits in the RV and runs through the lighting functions.
The most likely cause of this is a bad ground or dirt/corrosion in the trailer connector on the RV. It would take a very small wire brush or small screwdriver to clean on the 4-Way. This recently...
view full answer... - Troubleshooting A Leaking Everchill RV Refrigerator
- The typical cause of a leak on an Everchill RV Refrigerator w/ Freezer # 324-000119 is a blocked drain tube. You'll want to unplug the fridge and leave the doors open to thaw out the fridge as there is most likely an ice build up.
You'll need to remove the back of the fridge and you'll a tube running into a drainage pan. You can remove the tube from the pan and use a long tube cleaner brush to clean out any blockages in the drain tube.
Once the tube is cleaned out and the fridge is fully...
view full answer... - Troubleshooting A Leaking Everchill RV Refrigerator
- The typical cause of a leak on an Everchill RV Refrigerator w/ Freezer - 10.7 Cu Ft - 12V - Stainless Steel Item # 324-000119 is a blocked drain tube. You'll want to unplug the fridge and leave the doors open to thaw out the fridge as there is most likely an ice build up. You'll need to remove the back of the fridge and you'll see a tube running into a drainage pan. You can remove the tube from the pan and use a long tube cleaner brush to clean out any blockages in the drain tube.
Once...
view full answer... - Troubleshooting An Everchill RV Refrigerator That Freezes Up
- If your Everchill RV Refrigerator w/ Freezer # EV77FR is freezing up then I have the following troubleshooting recommendations:
1. First you'll need to thaw out the drain line. Turn off the power running to the fridge and leave the doors open so that the ice will melt. Once the ice is melted you can remove the lower back panel to gain access to the drain line and can ensure that it's clear using a pipe cleaner brush.
2. Check the temperature settings and lower them.
3. Check the ground...
view full answer... - Kwikee RV Steps Are Operating In Reverse When The Step Switch Is On
- It sounds like you have some wires flipped on Kwikee RV steps. I have attached an image I recommend you double check to ensure that your wiring is correct, as that may be the issue.
Additionally, it has been reported that the motor orientation could also be causing the opposite affect you're experiencing. What you'll want to do is ensure that the armature on the motor goes through a brush assembly, into the motor case which contains two permanent magnets.
If this is turned 180°, this...
view full answer... - Troubleshooting A Leaking Everchill Refrigerator W/ Freezer
- The typical cause of a leak on an Everchill RV Refrigerator w/ Freezer - 10.7 Cu Ft - 12V - Stainless Steel Item # 324-000119 is a blocked drain tube. You'll want to unplug the fridge and leave the doors open to thaw out the fridge as there is most likely an ice build up. You'll need to remove the back of the fridge and you'll a tube running into a drainage pan. You can remove the tube from the pan and use a long tube cleaner brush to clean out any blockages in the drain tube.
Once the...
view full answer... - Troubleshooting/Resetting Jacks On A Lippert Ground Control 3.0 That Have A Rear Sensor Error
- If your touchpad on your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set # LC675817 is showing an external sensor error, then that is indicating that you have a faulty connection to the rear sensor, or you may have some damaged wiring.
What you can do is check the connection and the wiring at your rear sensor and ensure it is not damaged or loose, and replace if needed.
If that checks out fine, then you can also try resetting the leveler....
view full answer... - Troubleshooting Installation of Ultra Faucets RV Shower Valve with Standard Shower Hose Connected
- The Ultra Faucets RV Shower Valve w/ Vacuum Breaker - Single Lever Handle - Brushed Nickel # 277-000024 has that offset hole in the vacuum breaker diverter on purpose. The vacuum breaker on this shower valve lets you attach a handheld shower set and it has an anti-siphon device that will prevent the backflow contamination of your clean water supply. The anti-siphon device consists of an air hole that will drain water back out of the hose. You will want to make sure the washer does not...
view full answer... - Troubleshooting A Greystone RV Griddle Ignitor That Won't Light The Burner
- Since the Greystone Outdoor RV Griddle and Grill # WAY34FR is lighting with a lighter but not by the ignitor you most likely either have a faulty electrode or there is build up on the burner blocking the ignitor from lighting the burner. I recommend first cleaning the burner by following the steps listed below:
1. Shut the gas down at control knob.
2. All components must be cooled down.
3. Get griddle plate off from assembly.
4. Use wire to brush the entire outer surface of the burner...
view full answer... - Troubleshooting 7 Way Wire Functions on a Camper
- It sounds like your wires are most likely all wired up correctly. If you are wanting to verify that, I recommend the Pollak 7-Way to RV Socket LED Circuit Tester # PK12741. A more likely culprit is probably damaged wiring somewhere along the circuit or possibly some corrosion built up around the running lights pin on the trailers 7-way. If you have a damaged wire you would want to splice in new wires individually for the ones damaged on your 7-way wiring or splice in a jacketed 7-way bundle...
view full answer... - Troubleshooting Lippert SolidSteps That Are Blocking The Screen Door From Closing
- Is your SolidStep Manual Fold-Down Steps for 29" to 36" Wide RV Door Frames # LC791575 hinge sitting flat on the bottom of the door frame? The hinge will need to sit flat up against the bottom and outside edge of the door frame like you can see in the attached video around the 7 minute mark. If not, that could be causing the bind up with your screen door. Typically the screen door is anywhere from 1/4"-1/2" above the door frame with a brush weather strip to keep out bugs so it shouldn't...
view full answer... - Troubleshooting Brake Lights That Stay On Even When Vehicle Is Off
- If the brake lights on your trailer (or vehicle) remain on even when the vehicle key is turned off this tends to suggest a problem with corrosion inside the 7-way socket on the vehicle or within the Hopkins 7-Pole to 4-Pole and 5-Pole Adapter # 37385.
On an RV-style 7-way the 12V auxiliary trailer power feed is carried on the contact at the 1-o-clock position as you look at the socket on the back of the vehicle. Internal corrosion within the socket, inside the plug connecting to the rear...
view full answer... - Troubleshooting A Newer Lippert Flow Max RV Water Pump That Isn't Working
- When you checked the fuse did you test it with a multimeter # PT89ZR to see if power was actually passing through to the water pump or did you just look at the fuse to see if it was blown? It's also not uncommon for there to be an in-line fuse at the pump and another at the dc distribution board if it's not ran directly to the battery. The quickest way to test this would be to prick into the casing of the power wire right at the pump to see what the voltage is. If you're not getting 12...
view full answer...
Go To Results